Welcome to HeavyEquipmentForums.
I can get to the right side with the door open but the battery is in the way on the left.
Jun 02, If it wasn't for the bushing removal problem I'm guessing it took 3 or 4 hours to clean up the holes, take measurements and machine the tapered bushings.
Edit: I just looked at the parts diagram I got from Bobcat and still don't see any weld in bushings on the Bobtach ears. Jan 25, Re: How to remove Bob-Tach in reply to David in SC, The pin that the bolt threads into is tapered where it goes into the lift arm, and if it is not tight it will allow the pin and bolt combo to turn, probably need an air impact wrench.
Bobtach bushing removal 14, Heat expands metal, the expansion is constrained by the bore causing the bushing's thickness to increase and as it cools, decreasing the OD of the bushing. I use that method to remove all bearing races and bushings where it will work. It's quick and easy. lumberjack, Jun 26, Remove the bushings from the tilt piston rod ends.
Install the new bushings in the rod ends using a hammer and bushing driver. These bushings do not have grease seals and will extend to both sides of the rod end. Step 9Missing: bobtach. Dec 27, I went to the dealer this morning and bought new pins, bushing and the updated dust seal and cap.
Getting the boring bar centered in the ears using tapered bushings.
dollars later I left with all the crap to fix it. I couldn't find any information on the net that really showed how the pins come out, from the outside it looks a bit confusing how it comes apart but once you get the pin losened from the.